Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
474 Configuration Manual, 11/2015, C79000-G8976-C252-10
You remove the information with the no redist-config command.
You distribute the routes with the
restribute command.
no redist-config
Description
With this command, you delete the information for the new external routes.
Note
This command is available only with layer 3.
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Call up the command with the following parameters:
no redist-config <Network> <Mask>
The parameters have the following meaning:
Target address of the route.
Subnet mask of this route
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The information for the route is deleted.
You create the information with the redist-config command.
To Next Page
Loading...
Need help?
General