Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
618 Configuration Manual, 11/2015, C79000-G8976-C252-10
9.7.3.7
redistribute
Description
With this command you specify which route information is forwarded by RIP.
Note
This command is available only with layer 3.
Requirement
You are in the RIP router configuration mode.
The command prompt is as follows:
cli(config-ripng)#
Syntax
Call up the command with the following parameters:
redistribute {static|connected|ospf} metric <integer(0-16)> [route-map <name(20)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
default
Default routes are distributed.
-
connected
Route information of local subnets (IP
interfaces) is distributed for which RIP
is not configured.
-
ospf
Routes learned by OSPF are distribut-
ed.
-
static
Static routes are distributed.
-
metric
Keyword for the metric of the external
standard route.
-
integer
Value of the metric (hop counter) 0 ... 16
15 longest possible distance
16: unreachable
route-map
Keyword for a route map.
-
name
Name of the route map.
Maximum of 20 characters
Result
The information forwarded by RIP has been specified.
Further notes
You disable the forwarding with the no redistribute command.
You display the setting and other information with the
show ipv6 rip command.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English