Network protocols
7.7 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
340 Configuration Manual, 11/2015, C79000-G8976-C252-10
● The interface is an IPv6 interface.
● The DHCPv6 relay agent is enabled.
● In "
remote-id type", userDefined is set.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call the command without parameter assignment:
ipv6 dhcp relay remote-id userDefined <user-specific-ascii string(128)>
The parameter has the following meaning:
Designation of the remote ID. max. 128 characters
The designation is specified.
You enable the remote ID with the ipv6 dhcp relay remote-id. command.
You enable the DHCPv6 relay agent with the
ipv6 address dhcp relay command.
You configure the interface as a router port with the
no switchport command.
You configure the remote ID type with the
ipv6 dhcp relay remote-id type command.
This section describes commands of the Simple Network Management Protocol (SNMP).
This section describes commands with which you display various settings.
To Next Page
Loading...
Need help?
General