Load control
10.4 Flow control
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
666 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call the command without parameters:
no mac-address-table aging
The "Aging" function is disabled.
You enable the "Aging" function with the mac-address-table aging command.
The flow control function monitors the incoming data traffic of a port. If there is overload
("Congestion", "Overflow") it sends a signal to the connection partner. If the flow control
function receives a signal at the sending end, it stops the data transmission to avoid loss of
data.
This section describes commands of the flow control function.
This section describes commands with which you display various settings.
show flow-control
Description
This command shows the settings of the flow control function.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General