Siemens SCALANCE XR-500

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
450 Configuration Manual, 11/2015, C79000-G8976-C252-10
9.2.2.1
router ospf
Description
With this command, you enable routing with OSPF and change to the OSPF Router
configuration mode.
Note
This command is available only with layer 3.
Requirement
● IPv4 routing is activated
● You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
router ospf
Result
Routing with OSPF is enabled.
You are now in the OSPF Router configuration mode.
The command prompt is as follows:
cli (config-ospf)#
Further notes
You disable routing with OSPF with the no router ospf command.
You enable IPv4 routing with the
ip routing command.