Siemens SCALANCE XR-500 Configuration Manual

Security and authentication
11.2 RADIUS client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
691
Syntax
Call up the command with the following parameters:
show radius server [{<ucast_addr> | <ip6_addr>}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
ucast_addr
Value for an IPv4 unicast address
Enter a valid unicast address.
ip6_addr
Value for an IPv6 address Enter a valid IPv6 address.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If no parameters are specified, all configured RADIUS servers are displayed.
Result
The RADIUS server configuration is displayed.
11.2.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
11.2.2.1
login authentication
Description
With this command, you enable authentication via a RADIUS server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
login authentication {radius | local-and-radius | radius-fallback-local}

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English