Siemens SCALANCE XR-500

Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
235
Further notes
You can reset the setting to the default with the no spanning-tree (properties) command.
You display these settings and other information with the commands that start with
show
spanning tree ...
.
6.3.5.2
no spanning-tree
Description
With this command, you reset the various properties of the spanning tree function to the
default value:
The default values are as follows:
Parameter
Default value
cost
if dynamic calculation of the path costs is not enabled:
• 200000 for physical interfaces
• 199999 for port channels
disable
The spanning tree function is enabled on the interface
link-type
• point-to-point
The connection is configured as full-duplex
•
shared
in all other cases
portfast
disabled
port-priority
128
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#