Diagnostics
12.1 Event and fault handling
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
772 Configuration Manual, 11/2015, C79000-G8976-C252-10
You display the status of the events and the clients with the show events config command.
You delete the settings with the
no event config command.
With this command, the clients are not enabled.
To enable the clients, use the
client config command.
Note
Changing several message types or clients
With each command call, you can only select one message type and one client.
If you want to process several message types or clients, it may be more efficient to f
irst
option and then disable individual elements.
no event config
Description
With this command, you configure which of the various message types of the device will no
longer be stored or forwarded.
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
To Next Page
Loading...
Need help?
General