Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
597
The value for the administrative distance is reset.
You specify the administrative distance with the distance command.
distribute-list route-map
Description
This command enables the filtering of the routing information according to a route map for
incoming or outgoing routing information.
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Call up the command with the following parameters:
distribute-list route-map <name(20)> {in | out}
The parameters have the following meaning:
Name of the routing table.
Maximum of 20 characters.
Incoming routing information is filtered.
Outgoing routing information is filtered.
The filtering is enabled.
no distribute-list route-map
Description
This command disables the filtering of the routing information according to a route map for
incoming or outgoing routing information.