Siemens SCALANCE XR-500

Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
241
Further notes
You can display the status of this function and other information with the show spanning-tree
interface
command with the detail option.
6.3.5.8
spanning-tree bpdu-receive
Description
With this command, you enable or disable the BPDU receive status at the port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree bpdu-receive{enabled|disabled}
The parameters have the following meaning:
Parameter
Description
Range of values / note
enabled
BPDU packets are received at the port
Default: enabled
disabled
BPDU packets are ignored at the port
-
Result
The BPDU receive status is enabled or disabled.
Further notes
You can display the status of this function and other information with the show spanning-tree
interface
command with the detail option.
6.3.5.9
spanning-tree bpdufilter
Description
With this command, you configure the BPDU transmit status for a port.