Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
293
no ipv6 unicast-routing
Description
With this command, you disable IPv6 routing function on the device.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameter assignment:
no ipv6 unicast-routing
IPv6 routing is disabled. On interfaces on which IPv6 is enabled, stateless autoconfiguration
is performed.
You enable IPv6 routing with the ipv6 unicast-routing command.
You display the IPv6 routing table with the
show ipv6 route command.
Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
To Next Page
Loading...
Need help?
General