Configuration
3.2 Load and Save
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
107
With this command, you call up the possible files or delete a specific file.
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Call up the command with the following parameters:
delete{showfiles|filetype<filetype>}
The parameters have the following meaning:
Shows the available files
Keyword for the file type to be deleted
The files are displayed or the file is deleted.
With the "show loadsave files" command, you can display the file types.
With this command, you activate and configure the password for a file.
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
To Next Page
Loading...
Need help?
General