Siemens SCALANCE XR-500

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
494 Configuration Manual, 11/2015, C79000-G8976-C252-10
9.2.4.15
ip ospf transmit-delay
Description
With this command, you specify the time required to transfer and LSA message.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
ip ospf transmit-delay <seconds (0 - 3600)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
seconds
Interval in seconds
0 - 3600
Result
The interval is specified.
Further notes
You delete the interval with the no ip ospf transmit-delay command.
9.2.4.16
no ip ospf transmit-delay
Description
With this command, you delete the interval.
Note
This command is available only with layer 3.