Siemens SCALANCE XR-500 - Distribute-List Route-Map

Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
616 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call up the command with the following parameters:
no distribute prefix <ip6_add> {in | out}
The parameters have the following meaning:
Parameter
Description
Values
ip6_add
IPv6 address
Enter a valid IPv6 address
in
The filtering for incoming routing information is
disabled.
-
out
The filtering for outgoing routing information is
disabled.
-
Result
Filtering is disabled.
Further notes
You enable filtering with the distribute prefix command.
You display the configured filters with the
show ipv6 rip filter command.
9.7.3.5
distribute-list route-map
Description
This command enables the filtering of the routing information according to a route map for
incoming or outgoing routing information.
Requirement
You are in the RIPng router configuration mode.
The command prompt is as follows:
cli(config-ripng)#