Siemens SCALANCE XR-500

Diagnostics
12.1 Event and fault handling
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
764 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call up the command with the following parameters:
show interface transceiver details <if-id>
The parameter has the following meaning:
Parameter
Description
if-id
Interface identifier
Result
Hardware information (model, serial number) and operating parameters (data transmission
rate, voltage and current consumption as well as the transmit and receive power) for SFP
port are displayed.
12.1.3.9
show power-line-state
Description
This command shows the status of the power supply.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show power-line-state
Result
The status of the power supply is displayed.
12.1.4
clear logbook
Description
With this command, you delete the content of the logbook.