Siemens SCALANCE XR-500

Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
609
9.7.1.2
show ipv6 rip filter
Description
This command shows the configured filters.
Requirement
● Routing with RIPng is enabled.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ipv6 rip filter
Result
The configured SNMP filters are displayed.
9.7.1.3
show ipv6 rip peer-table-status
Description
This command shows the peer status information
Requirement
● Routing with RIPng is enabled.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ipv6 rip peer-table-status
Result
The information is displayed.