Security and authentication
11.3 MAC access control list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
698 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
show access
-lists [ [{ip | mac}] <access
-list-number (1
-128)> ]
The parameters have the following meaning:
Selects IP-based access lists (IP ACL)
Selects MAC-based access lists (MAC
-
Number of the access control list
If you do not select any parameters from the parameter list, the configuration of all access
control lists will be displayed.
The configuration of the access control lists is displayed.
show interface access lists
Description
This command shows the access control list of one or all interfaces.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show interface access-lists [<interface-type><interface-id>]
The parameters have the following meaning:
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the configuration is displayed for
all available interfaces.
To Next Page
Loading...
Need help?
General