Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
534 Configuration Manual, 11/2015, C79000-G8976-C252-10
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call the command without parameter assignment:
no ipv6 ospf
OSPFv3 on the interface is enabled.
You configure the router ID with the router id command.
You enable OSPFv3 with the
ipv6 ospf area command.
You show the configuration of the OSPFv3 interface with the
show ipv6 ospf interface
command.
ipv6 ospf dead-interval
Description
With this command, you specify the time that can elapse before the neighbor router is
assumed to have "failed". This means that no more Hello packets were received from it
during this time.
Note
This command is available only with layer 3.
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call up the command with the following parameters:
ipv6 ospf dead-interval <interval>
To Next Page
Loading...
Need help?
General