Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
631
Syntax
Call up the command with the following parameters:
no match destination ipv6 <IPv6 address> <Prefix Length>
The parameters have the following meaning:
Parameter
Description
Range of values / note
IPv6 address
IPv6 address Enter the IPv6 address of the destination on which the filter-
ing is based.
Prefix Length
Decimal representation of the mask
as a number of "1" bits
0 ... 128
Enter the mask of the destination on which the filtering is
based.
Result
The filter for the destination IPv6 address is deleted.
Further notes
You create a filter for the destination IPv6 address with the match destination ipv6
command.
You create a filter for the destination IPv4 address with the
match destination ip command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
9.8.3.5
match interface
Description
With this command, you specify whether or not the routing information for a route map is
filtered based on the interface.
Note
This command is available only with layer 3.
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English