Siemens SCALANCE XR-500

Diagnostics
12.1 Event and fault handling
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
762 Configuration Manual, 11/2015, C79000-G8976-C252-10
Result
Startup information is shown.
12.1.3.6
show logbook
Description
With this command, you display the content of the logbook. The log entries are categorized
differently.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show logbook
or
Call up the command with the following parameters:
show logbook { info | warning | critical }
The parameters have the following meaning:
Parameter
Description
info
All log entries of the categories "Information", "Warning" and "Critical" are
displayed.
warning
All log entries of the categories "Warning" and "Critical" are displayed.
critical
All log entries of the category "Critical" are displayed.
Result
The content of the logbook is displayed.
12.1.3.7
show cabletest interface
Description
This command shows the result of the cable test of the interface.