Network protocols
7.9 HTTP server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
374 Configuration Manual, 11/2015, C79000-G8976-C252-10
With this command, you reset the SMTP port to the default.
The default value is 25.
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Call the command without parameters:
no smtp-port
The SMTP port is reset to the default value.
You configure the setting with the smtp-port command.
You display the setting with the
show smtp-port command.
This section describes commands of the Hypertext Transfer Protocol (HTTP).
This section describes commands with which you display various settings.
show ip http server status
Description
This command shows the status of the HTTP server.
To Next Page
Loading...
Need help?
General