Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
531
With this command, you specify the ID of the router.
Note
This command is available only with layer 3.
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Call up the command with the following parameters:
router-id <IPv4-Address>
The parameter has the following meaning:
IPv4-Address Router ID Specify the ID in the IPv4 address format.
x.x.x.x
The ID of the router is specified.
You display the router ID and other information with the show ipv6 ospf interface
command.
To Next Page
Loading...
Need help?
General