Siemens SCALANCE XR-500 - Ip Igmp Snooping Switch-Ip

Layer 2 management protocols
8.2 IGMP snooping
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
397
Syntax
Call up the command with the following parameters:
ip igmp snooping clear counters [Vlan<vlan id>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
vlan
Keyword for a VLAN connection
-
vlan id
Number of the addressed VLAN 1 ... 4094
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select a VLAN, the counters of all VLANs will be deleted.
Result
The counters are deleted.
8.2.2.5
ip igmp snooping switch-ip
Description
With this command, you configure the IP address of the source for IGMP snooping.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip igmp snooping switch-ip<switch-ipaddr>
The parameter has the following meaning:
Parameter
Description
Range of values / note
switch-ipaddr
Address of the source Specify a valid IP address.
Default: 0.0.0.0
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".