Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
496 Configuration Manual, 11/2015, C79000-G8976-C252-10
The parameter has the following meaning:
Priority 0 ... 255
The priority is specified.
You can reset the priority to the default with the no ip ospf priority command.
You display the router ID and other information with the
show ip ospf interface command.
no ip ospf priority
Description
With this command, you reset the value for the priority to the default value.
Note
This command is available only with layer 3.
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if)#
Call the command without parameter assignment:
no ip ospf priority
The value for the priority is reset to the default.
You configure the priority with the ip ospf priority command.
You display the router ID and other information with the
show ip ospf interface command.
To Next Page
Loading...
Need help?
General