Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
517
The address range is deleted.
You configure the address range with the no area range command.
You configure the area with the
area command.
You can display the status of this function and other information with the
show ipv6 ospf -
area-range / summary-address
command.
area summary-prefix
Description
With this command, you assign an area ID an address range. The address range is used to
group the external routes.
Note
This command is available only with layer 3.
● The area is of the type NSSA
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
To Next Page
Loading...
Need help?
General