Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
69
Call up the command with the following parameters:
clear counters [<interface-type><interface-id>]
The parameters have the following meaning:
Type or speed of the interface
Specify a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If no parameters are specified, the counters for all interfaces are reset.
The counters of the interface are reset.
You can display the statistical information of the interfaces with the show interfaces -
counters
command.
clear line vty
Description
With this command, you close a console session on the device.
With the
forceful-clear option, you close a session and that is not reacting.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
To Next Page
Loading...
Need help?
General