Siemens SCALANCE XR-500

Network protocols
7.11 ARP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
381
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no arp <ip address>
The parameter has the following meaning:
Parameter
Description
Range of values / note
ip address
Value of the IP address whose entry will be deleted
IP address or IP alias
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 42)".
Result
The entry is deleted from ARP cache.
Further notes
You generate a static entry in the ARP cache with the arp command.
You can display the status of this function and other information with the
show ip arp
command.
You configure the router port with the
no switchport command.
7.11.2.3
arp timeout
Description
With this command, you configure the timeout setting of the ARP cache.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#