System time
5.2 NTP Client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
152 Configuration Manual, 11/2015, C79000-G8976-C252-10
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you change to the Network Time Protocol (NTP).
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
ntp
You are now in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
You exit the NTP configuration mode with the end or exit command.
To Next Page
Loading...
Need help?
General