Siemens SCALANCE XR-500 Configuration Manual

Network protocols
7.7 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
355
7.7.2.9
no snmp group
Description
With this command, you delete the details of an SNMP group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp group <GroupName> user <UserName>security-model{v1|v2c|v3}
The parameters have the following meaning:
Parameter
Description
Range of values / note
GroupName
Name of the group
max. 32 characters
user
Keyword for the user name
-
UserName
Name of the user
max. 32 characters
security-model
Specifies which security settings are
used for sending
•
v1
•
v2c
•
v3
Result
The details of the group are deleted.
Further notes
You change the details of an SNMP group with the snmp group command.
You display the created SNMP groups with the
show snmp group command.
You display the created SNMP user with the
show snmp user command.
7.7.2.10
snmp notify
Description
With this command, you configure the details of the SNMP notifications.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English