Siemens SCALANCE XR-500 Configuration Manual

System time
5.3 SNTP Client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
158 Configuration Manual, 11/2015, C79000-G8976-C252-10
5.3.3
Commands in the SNTP configuration mode
This section describes commands that you can call up in the SNTP configuration mode.
In the Global configuration mode, enter the
sntp command to change to this mode.
● If you exit the SNTP configuration mode with the
exit command, you return to the Global
configuration mode.
● If you exit the SNTP configuration mode with the
end command, you return to the
Privileged EXEC mode.
5.3.3.1
sntp client addressing-mode
Description
With this command, you configure the addressing mode of the SNTP client as unicast or
broadcast.
Requirement
● The SNTP client is activated.
● You are in the SNTP Configuration mode.
The command prompt is:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
sntp client addressing-mode{unicast|broadcast}
The parameters have the following meaning:
Parameter
Description
Range of values / note
unicast
configures the SNTP client in unicast
mode
Default: unicast enabled
broadcast
configures the SNTP client in broad-
cast mode
-
Result
The addressing mode of the SNTP client is configured.
Further notes
You display this setting and other information with the show sntp status command.
You display the settings for the unicast mode with the
show sntp unicast-mode status
command.
You display the settings for the broadcast mode with the
show sntp broadcast-mode status
command.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English