Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
279
dcp forwarding
Description
With this command, you configure the forwarding behavior of the interface for DCP frames.
Note
PNIO configuration
Since DCP is a PROFINET protocol, the configuration created here is only effective with the
VLAN associated with the TIA interface.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
dcp forwarding {block|forward}
The parameters have the following meaning:
The forwarding behavior of the interface for DCP frames is configured.
This section describes the commands relevant for working with IPv6.
clear ipv6 traffic
Description
With this command, you reset the statistics counters to zero.
To Next Page
Loading...
Need help?
General