Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
607
Call up the command with the following parameters:
ip rip send [demand] version (1 | 2 | 12 | none)
The parameters have the following meaning:
Updates are sent only when requested.
Only RIPv1 updates are sent. -
Only RIPv2 updates are sent.
RIPv1 and RIPv2 updates are sent.
It has been specified which RIP version outgoing updates need to have.
no ip rip send version
Description
This command specifies that there is no restriction relating to the version of outgoing RIP
updates. Updates according to RIPv1 and RIPv2 are sent.
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call the command without parameters:
no ip rip send version
All RIP updates are sent.
This section describes the commands relevant for working with routing with RIPng.
To Next Page
Loading...
Need help?
General