Load control
10.2 Static MAC filtering
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
655
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameters:
no storm-control level
The value for the storm control function is reset to the default.
You configure the value for the storm control function with the storm-control level
command.
This section describes commands for filtering data packet on an interface.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
mac-address-table block static multicast
Description
With this command, you configure a static multicast MAC address without outgoing ports.
To Next Page
Loading...
Need help?
General