Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
487
Call the command without parameter assignment:
no ip ospf cost
The costs are deleted.
You create the costs with the ip ospf cost command.
You show the configuration of the OSPF interface with the
show ip ospf interface
command.
ip ospf dead-interval
Description
With this command, you specify the time that can elapse before the neighbor router is
assumed to have "failed". This means that no more Hello packets were received from it
during this time.
Note
This command is available only with layer 3.
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Call up the command with the following parameters:
ip ospf dead-interval <seconds (0-0x7fffffff)>
The parameter has the following meaning:
To Next Page
Loading...
Need help?
General