Network protocols
7.6 DHCPv6 Relay Agent (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
334 Configuration Manual, 11/2015, C79000-G8976-C252-10
You enable the DHCPv6 relay agent with the ipv6 dhcp relay. command.
You display the information with the
show ipv6 dhcp relay information command.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
ipv6 dhcp relay remote-id
Description
With this command, you specify whether the DHCP relay agent option 37 (Remote ID) is
used.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
ipv6 dhcp relay remote-id {enable | disable}
The parameters have the following meaning:
The Remote ID is activated.
To Next Page
Loading...
Need help?
General