Siemens SCALANCE XR-500

Network protocols
7.3 DHCPv4 client (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
308 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call the command without parameters:
ip dhcp config-file-request
Result
The DHCP config file request option is enabled.
Further notes
You disable the DHCP config file request option with the no ip dhcp config-file-request
command.
7.3.2.2
no ip dhcp config-file-request
Description
With this command, you disable the DHCP config file request option.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip dhcp config-file-request
Result
The DHCP config file request option is disabled.
Further notes
You enable the DHCP config file request option with the ip dhcp config-file-request
command.