Siemens SCALANCE XR-500 Configuration Manual

Description
2.7 General CLI commands
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
50 Configuration Manual, 11/2015, C79000-G8976-C252-10
Result
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
2.7.3
exit
Description
With this command, you close the current mode.
Syntax
Call the command without parameters:
exit
Result
The current mode was exited. You are then at the next higher level.
If you are in Privileged EXEC Modus or in User EXEC Modus mode, you will be logged out.
2.7.4
do
Description
With this command, you can execute the commands from the Privileged EXEC mode in any
configuration mode.
Syntax
Call up the command with the following parameters:
do [command ]
To do this, you replace
[command ] with the command from the Privileged EXEC mode that
you want to execute.
Example
You are in the Interface configuration mode and you want to execute the write startup-
config
command from the Privileged EXEC mode.
cli(config-if-$$)# do write startup-config

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English