Siemens SCALANCE XR-500 Configuration Manual

Network structures
6.2 Link aggregation
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
205
Further notes
You enable the setting with the transparent-vlan command.
6.2
Link aggregation
This section describes commands that configure or manage the bundling of interfaces or
connections between devices.
6.2.1
The "show" commands
This section describes commands with which you display various settings.
6.2.1.1
show etherchannel
Description
This command shows the settings of the Etherchannel.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show etherchannel [[channel-group-number]
{detail|load-balance|port|port-channel|summary|protocol}]
The parameters have the following meaning:
Parameter
Description
channel-group-
number
Number of the Channel-Group
detail
Detailed display of the settings
load-balance
Shows which load balancing method is enabled
port
Information on the Etherchannel port
port-channel
Information on the Port-Channel
summary
Brief overview of the settings of a Channel-Group
protocol
Specification of the protocol set for a Channel-Group
If you do not select any parameters from the parameter list, the settings of all channels will
be displayed in detail.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English