Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
298 Configuration Manual, 11/2015, C79000-G8976-C252-10
ipv6 address dhcp stateless
Description
With this command, you enable DHCPv6. The interface however only obtains the
configuration setting via DHCPv6.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call the command without parameter assignment:
ipv6 address dhcp
The interface only obtains the configuration setting via DHCPv6.
You disable DHCPv6 with the no ipv6 address dhcp command.
You configure the interface as a router port with the
no switchport command.
You show the setting with the
show ipv6 dhcp interface command.
You can display the statistics of the DHCPv6 client with the
show ipv6 dhcp client
statistics
command.
no ipv6 address dhcp
Description
With this command, you delete the IPv6 address and disable DHCPv6.
To Next Page
Loading...
Need help?
General