Siemens SCALANCE XR-500

Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
194 Configuration Manual, 11/2015, C79000-G8976-C252-10
Result
The operating mode is configured.
Further notes
You reset the operating mode to the default with the no switchport mode command.
You display this setting and other information with the
show vlan port config command.
You configure the interface as a switch port with the
switchport command.
6.1.3.10
no switchport mode
Description
With this command, you reset the operating mode for the switch port to the default.
The default value is Hybrid.
Requirement
● The interface is configured as a switch port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport mode
Result
The setting is reset to the default value.
Further notes
You configure the operating mode with the switchport mode command.
You display this setting and other information with the
show vlan port config command.
You configure the interface as a switch port with the
switchport command.