Siemens SCALANCE XR-500 - Ip Igmp Vlan-Snooping

Layer 2 management protocols
8.2 IGMP snooping
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
395
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip igmp snooping version {v1 | v2 | v3}
The parameters have the following meaning:
Parameter
Description
v1
IGMPv1
v2
IGMPv2
v3
IGMPv3
Result
The version of IGMP used by the device is specified.
8.2.2.2
ip igmp vlan-snooping
Description
With this command, you enable IGMP snooping for all VLANs.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ip igmp vlan-snooping
Result
IGMP snooping is enabled for all VLANs.