Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
77
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you change to the Interface configuration mode.
There you can edit the settings for one interface. You select the interface with the
parameters of this command. If you specify a logical interface that does not exist, it will be
created. The name of the selected interface is displayed in the command prompt.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
interface{cpu0|vlan<vlan
-id(1
-4094)>|port
-channel<port
-channel
-id(1
-8)>|
<interface-type><interface-id>}
The parameters have the following meaning:
The configuration mode for the "Out of
Band Management interface" is called
-
Keyword for a VLAN connection -
Number of the addressed VLAN
Keyword for a port channel connection
Number of the addressed port channel
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
To Next Page
Loading...
Need help?
General