Configuration
3.5 PoE
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
120 Configuration Manual, 11/2015, C79000-G8976-C252-10
show pse status
Description
This command shows the current settings of the PoE power supply of the device.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameter assignment:
show pse status
The current settings of the PoE power supply of the device are displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
poe pse MaximumPower
Description
With this command you can set a value for the parameter "Maximum Power" for SCALANCE
XM-400. This sets the maximum power that a PSE provides to supply PoE devices.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General