Siemens SCALANCE XR-500

Network protocols
7.12 SSH server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
384 Configuration Manual, 11/2015, C79000-G8976-C252-10
7.12.2.1
ssh-server
Description
With this command, you enable the SSH protocol on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ssh-server
As default the function is "enabled".
Result
The SSH protocol is enabled on the device.
Further notes
You disable the SSH protocol with the no ssh-server command.
7.12.2.2
no ssh-server
Description
With this command, you disable the SSH protocol on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ssh-server