Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
630 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
match destination ipv6 <IPv6 address> <Prefix Length>
The parameters have the following meaning:
IPv6 address Enter the IPv6 address of the destination on which the filter-
Decimal representation of the mask
as a number of "1" bits
0 ... 128
Enter the mask of the destination on which the filtering is
The filter for the destination IPv6 address is created.
You delete the filter for the destination IPv6 address with the no match destination ipv6
command.
You create a filter for the destination IPv4 address with the
match destination ip command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
no match destination ipv6
Description
With this command, you delete the filter for the destination IPv6 address.
Note
This command is available only with layer 3 (IPv6).
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
To Next Page
Loading...
Need help?
General