Siemens SCALANCE XR-500 - Set Metric

Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
645
Syntax
Call up the command with the following parameters:
no match tag <value (1-0xffffff)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
value
Value of the tag 1 ... 0xffffff
You can enter the value in decimal or
hexadecimal.
Result
The filter for a tag is deleted.
Further notes
You create the filter for a tag with the match tag command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
9.8.3.19
set metric
Description
With this command, you specify whether the routing information is forwarded with a changed
metric.
Note
This command is available only with layer 3.
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#