Siemens SCALANCE XR-500 Configuration Manual

Network protocols
7.4 DHCPv6 client (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
309
7.3.2.3
ip dhcp client mode
Description
With this command, you configure the type of identifier with which the DHCP client logs on
with its DHCP server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp client mode {mac|client-id<client-id>|sysname|pnio-name-of-station}
The parameters have the following meaning:
Parameter
Description
Range of values / note
mac
The client registers with its MAC ad-
dress
-
client-id
The client registers with the assigned
ID
-
client-id
Name of the assigned ID
max. 32 characters
sysname
The client registers with the assigned
system name
-
pnio-name-of-
station
The client registers with the PNIO
name. The name is assigned with the
PST tool.
-
Result
The registration mode of the DHCP client is configured.
7.4
DHCPv6 client (IPv6)
This section describes commands for DHCPv6.
7.4.1
The "show" commands
This section describes commands with which you display various settings.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English