Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
225
Call up the command with the following parameters:
spanning-tree[mst <instance-id(1-64)>] priority <value(0-61440)>
The parameters have the following meaning:
Keyword for a Multiple Spanning Tree
-
Value for the priority 0 ... 61440
You can only change the value for the priority in the steps of 4096.
The priority of the device is configured.
You can reset the setting to the default with the no spanning-tree priority command.
You display this setting and other information with the commands that start with
show
spanning-tree ...
.
no spanning-tree priority
Description
With this command, you reset the priority of the device back to the default value.
The default value is 32768.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General