Siemens SCALANCE XR-500

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
460 Configuration Manual, 11/2015, C79000-G8976-C252-10
9.2.3.8
no area
Description
With this command, you remove or change an area of the type "Stub" or "NSSA".
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no area <area-id>
[
{ stub | nssa }
]
The parameters have the following meaning:
Parameter
Description
Range of values / note
area-id
Area-ID enter a valid ID.
x.x.x.x
x = 0 ... 255
The area ID 0.0.0.0 is reserved for the backbone area
and cannot be deleted.
stub
Stub area
--
nssa
NSSA area
--
Result
The area is removed or changed.