Siemens SCALANCE XR-500 Configuration Manual

Network protocols
7.4 DHCPv6 client (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
319
Further notes
You remove the request with the no ipv6 dhcp client request command.
7.4.2.9
no ipv6 dhcp client request
Description
With this command, you remove the request for the configuration parameter.
Requirement
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ipv6 dhcp client request {dns-server-address | domain-name | sntp-server-address |
option <code (1-100)>}
The parameters have the following meaning:
Parameter
Description
Range of values / note
dns-server-
address
IPv6 address of the DNS server -
domain-name
Domain name
-
sntp-server-
address
IPv6 address of the SNTP server -
option
Keyword for the option code
-
code
ID of the DHCPV6 option Specify the required ID of the
DHCPv6 option.
1 ... 100
Result
The required configuration parameter is removed.
Further notes
You configure the request with the ipv6 dhcp client request command.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English